Re: Problems Installing Sonicwall TZ-215 with Uverse Internet I have a TZ105 and setting the NVG589 up in 'pass-though' is quite simple. What is a problem, is setting up a PPTP VPN in the SW and getting a connection to the VPN Server. SonicWALL TZ 170 Getting Started Guide Page 7 2. Enter 192.168.168.168 (the default LAN management IP address) in the Location or Address field. The SonicWALL Setup Wizard launches and guides you through the configuration and setup of your SonicWALL TZ 170. If the SonicWALL Setup Wizard Does Not Appear.
In the SSL Server VPN settings, you may want to change the default port to 443 if the VPN users travel frequently and find themselves behind highly restrictive firewalls that block outbound access by port. Port 443 is usually not blocked by even the most restrictive firewalls. If you decide to do this, keep in mind that you will need to change the Sonicwall management port to something other than the default port 443. Do this under the system administration menu. You will also need to double check that port 443 is not being used for other services such as an Exchange/OWA HTTPS connection.
In SSL VPN Portal Settings you can customize the message that appears to VPN users. Just edit the HTML text to create custom messages or to link custom logos. Under Client Settings, follow these instructions.
Interface: Select your LAN Interface, by default X0 NetExtender IP: SSL VPN will not use the DHCP address pool from either the firewall or from a server on your network. For this reason, you must specify a range of usable IP addresses for the VPN client. Make sure the address pool is outside the scope of your DHCP server's pool.
![]()
DNS Server: Configure your internal DNS server IP address Domain: Configure the internal domain WINS: If you use WINS, enter the IP address of your WINS server. Default Session Timeout: I like to increase it from the default to avoid constant disconnects. Enable Web/SSH Management over VPN: Enabled if you want VPN access to manage the Sonicwall device. Exit Client after Disconnect: Enabled will shut down the NetExtender client program. Uninstall Client after Exit: If enabled will uninstall client software after disconnect (not recommended in most cases). Lastly, in the Client Routes, click on Add Client Routes and select LAN Subnet to allow the VPN client access to the LAN subnet.
Comments are closed.
|
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |